Cooling fans died

Post Reply
ScubaZan
Posts: 8
Joined: Mon Apr 13, 2015 3:55 pm

Cooling fans died

Post by ScubaZan » Thu Apr 30, 2015 1:38 pm

Need help.

After a really good print, I went to slice another and run but both board and extruder fan are not working. Just to check and see if it was the fan I hooked one up to a 9V battery and it spun fine.

Is there a config setting I can try, or is the board dead?

I already tried resetting the board with no luck.

Please help.

Thank you,

Zan :cry:
Top
zhangxueyou
Posts: 1405
Joined: Fri Feb 06, 2015 1:33 pm

Re: Cooling fans died

Post by zhangxueyou » Thu Apr 30, 2015 2:25 pm

Please use multimeter to check the voltage of "+" and "-" at fan pins.
QQ截图20150430142327.png
QQ截图20150430142327.png (66.1 KiB) Viewed 5810 times
Top
ScubaZan
Posts: 8
Joined: Mon Apr 13, 2015 3:55 pm

Re: Cooling fans died

Post by ScubaZan » Fri May 01, 2015 11:16 pm

I used an analog multimeter and the needle did the move, so the reading is 0.0
Top
zhangxueyou
Posts: 1405
Joined: Fri Feb 06, 2015 1:33 pm

Re: Cooling fans died

Post by zhangxueyou » Mon May 04, 2015 11:47 am

Please test the voltage between "D17" and "GND", "Vin" and "GND" seperately. "D17" and "Vin" have been highlighted in the picture.
The power of fans comes from D17.
QQ截图20150504114143.png
QQ截图20150504114143.png (309.81 KiB) Viewed 5782 times
Top
Post Reply

Return to “Others”