Tried printing a shot glass. Went allright in the beginning, but then half of the print it started ticking..zhangxueyou wrote:What is temperature reading when it's ticking?k3tzor wrote:zhangxueyou wrote:1. Swap the exturder motor driver(A4988) with x or y motor driver. Check if the extruder motor works after heating. (To check if extruder motor driver is broken)
2. Plug x or y motor to extruder connector, check if the motor works after heating. (To check if extruder motor is abnormal)Today the test went a bit better, but the extruder motor isn't that strong enough seems to be. When it's starting a new print, and it went a bit cold, before it would have a clog. When i try pushing it trough before the print. Try it again, print starts up, but then suddenly in the middle of the print it starts ticking again.. So how come????? I was making progress, and now it's in the middle of a print
- Already tried that with some new stepper drivers
- This does the same, so this is strange.
Here is an album with the images, as you see in the middle and at the top:
http://imgur.com/a/9A8FX
These are my slic3r settings:
http://imgur.com/a/PPRpN
So i can not finish a good print .. Waist of filament...