Geetech a10m x-axis belt motor slide

[Wfire]

I have turn belt , no change

[Wfire]

???

[William]

Hi，
it may be that the belt is too tight, you can adjust it properly.

[Wfire]

I repeat once again:
whatever the setting of the belt: stretched, relaxed, half stretched.

it goes on the engine side, always always always

[Wfire]

[William]

Hi，you can adjust the position of the buckle.

[Wfire]

Hi，you can adjust the position of the buckle.

hello, I think you take me for a moron, I have a cr10 and an anet, so I can adjust a strap I can adjust loops too.
the strap twists it and not flat ok. I bought the printer with this defect. so I repeat a few whatever the location it stays in the same place. I'm going to twitter and make a video on the youtube channel at least if that means avoiding people buying your poor quality material ....

[William]

I am so sorry, you can contact the salesman to replace the belt.