GT2560 Rev. A+ schematic

Post by **_kaktus_** » Wed Jun 20, 2018 12:39 pm

HI

[attachment=1]Hardware_GT2560_RevA+_1.png[/attachment]
[attachment=0]Hardware_GT2560_RevA+_2.png[/attachment]

A_Camera · Post by **A_Camera** » Fri Jul 20, 2018 7:54 pm

[quote=5a2v0 post_id=84664 time=1529413397 user_id=66394]
hi, I have a geeetech prusa i3 pro b.
on the pwm fan pin i got 5v when repetier host was set at 100% fan.

is it normal or i must have 12v?
[/quote]

No, it is not normal. 100% should be 12V not 5V. If you get 5V you measure it wrong or something is wrong with your card. PWM output should give you 6V if fan speed is set to 50%, 5V is about 42%.

A_Camera · Post by **A_Camera** » Fri Jul 20, 2018 7:55 pm

Ginko, you are wrong.

Post by **Gingko** » Mon Jul 23, 2018 7:17 pm

Sorry I made the mistake!

I check it, it's around 12V when the rate is 100%.
Thanks for pointing out.

Geeetech

GT2560 Rev. A+ schematic

Re: GT2560 Rev. A+ schematic

Re: GT2560 Rev. A+ schematic

Re: GT2560 Rev. A+ schematic

Re: GT2560 Rev. A+ schematic