Could you please take a picture of LCD?John LaBaff wrote:Finally got the firmware to upload to the device. Now LCD screen is not showing anything on the display except blocks. What happened? The Repetier software can still control the printer.
Also trying to set the home points on the printer.
Trying to update firmware to Merlin on Sanguinololu board
-
zhangxueyou
- Posts: 1405
- Joined: Fri Feb 06, 2015 1:33 pm
Re: Trying to update firmware to Merlin on Sanguinololu boar
-
John LaBaff
- Posts: 7
- Joined: Tue Apr 07, 2015 10:01 am
Re: Trying to update firmware to Merlin on Sanguinololu boar
- LCD1.jpg (192.54 KiB) Viewed 7909 times
-
zhangxueyou
- Posts: 1405
- Joined: Fri Feb 06, 2015 1:33 pm
Re: Trying to update firmware to Merlin on Sanguinololu boar
I think you'd better contact the customer service to tell them your problems.
Re: Trying to update firmware to Merlin on Sanguinololu boar
I keep getting this error message...
Arduino: 1.6.0 (Mac OS X), Board: "Arduino Mega or Mega 2560, ATmega2560 (Mega 2560)"
sketch_jun27b.ino:2:1: error: 'BlinkM' does not name a type
Error compiling.
This report would have more information with
"Show verbose output during compilation"
enabled in File > Preferences.
[img]IMG_2883.png[/img]
Arduino: 1.6.0 (Mac OS X), Board: "Arduino Mega or Mega 2560, ATmega2560 (Mega 2560)"
sketch_jun27b.ino:2:1: error: 'BlinkM' does not name a type
Error compiling.
This report would have more information with
"Show verbose output during compilation"
enabled in File > Preferences.
[img]IMG_2883.png[/img]