It is inside the hole.
il est dans le trou
Assemble the X-Z axis Problem
-
danger_dan46819
- Posts: 1
- Joined: Sat May 23, 2015 7:54 am
Re: Assemble the X-Z axis Problem
The threaded rods are 8mm (.311 inch in Diameter) I had to ream the holes out to .312" (5/16") so they would be round and rotate freely. Also lubricated the brass nut and the hole that was reamed. That quieted everything no more squeaking. My problem is I could not get anything to move until I moved the limit switches to the MIN pins not the MAX pin plugs.
-
zhangxueyou
- Posts: 1405
- Joined: Fri Feb 06, 2015 1:33 pm
Re: Assemble the X-Z axis Problem
Yes, the endstops should be connected to MIN slots.danger_dan46819 wrote:The threaded rods are 8mm (.311 inch in Diameter) I had to ream the holes out to .312" (5/16") so they would be round and rotate freely. Also lubricated the brass nut and the hole that was reamed. That quieted everything no more squeaking. My problem is I could not get anything to move until I moved the limit switches to the MIN pins not the MAX pin plugs.