What causes this problem.
What causes this problem.
Why? This is a dual printer and were only printing one color. It printed great for most of it then went stupid
- Attachments
-
- IMG_20190601_155049.jpg (147.88 KiB) Viewed 4711 times
-
- IMG_20190601_155042.jpg (191.3 KiB) Viewed 4711 times
-
- IMG_20190601_155032.jpg (187.32 KiB) Viewed 4711 times
Re: What causes this problem.
We got it. Its a duel feed extruder. We only had filament on one side. The top of the dog uses the second feed.
Re: What causes this problem.
Perfect timing on this question. I just printed the dog last night and had the same issue when I took it off. Couldn't figure out what happened. Yup, I only loaded extruder 1.
Re: What causes this problem.
How do I get filament down to the hotend of an A10M? The display only knows e0. When I do Change filament it does eo, nothing about e1.