Hello,
I build a housing for the A30 with a hater.
Is there a way to switch the heater with a GCODE command... or does the A30 have a extra output at the mainbord to switch a relay?
Greetings, Michael
switch a housing heater
Re: switch a housing heater
Hi, if you use Repetier Host, you can use this: https://www.repetier.com/firmware/v091/
and select the temperature，and select to Enable heated bed support，Select Heater pin.
I hope this can help you.
and select the temperature，and select to Enable heated bed support，Select Heater pin.
I hope this can help you.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!