A20M and ABS

Post Reply
capt1701a
Posts: 4
Joined: Fri May 10, 2019 1:01 am

A20M and ABS

Post by capt1701a » Sat May 25, 2019 12:07 am

Hi everyone,

I 'm new to the world of 3D printing and finding it very frustrating due to the poor or lack of instructions. On the A20M has anyone tried printing using ABS, as I have to force it through by hand, also it is not sticking to the bed. I have tried the hot end from 230 to 250C and the heat bed at 100C. The printer worked OK on PLA, besides not sticking to the bed correctly, even with glue.

Any help would be much appreciated
Thanks
Top
User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: A20M and ABS

Post by William » Sat May 25, 2019 9:08 am

Hi，ABS's consumables temperature is around 210°-230°. Are your consumables placed in a dry place?
-Keep your mind and try to test it. :)
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Top
capt1701a
Posts: 4
Joined: Fri May 10, 2019 1:01 am

Re: A20M and ABS

Post by capt1701a » Sat May 25, 2019 3:04 pm

yes, they are in a dry place
Top
Danny.B
Posts: 7
Joined: Sun Jun 02, 2019 8:56 pm

Re: A20M and ABS

Post by Danny.B » Sun Jun 02, 2019 10:02 pm

vert wrote: ↑
Tue May 28, 2019 1:46 pm
 ABS is rather hard to print without ABS slurry and a enclosure not to mention all the fumes it gives off.
True, but in the advertisement it says that it can print ABS.

greetings
Top
Post Reply

Return to “Geeetech A20M”