I'm having an issue with my A10M not retracting on one of the filaments, upornia when using menu to gotporn control motion also get fails to xnxx retract
I can run it forward, but it will not run reverse.
firmware or motor?
firmware or motor?
-
MatthewD01
- Posts: 2
- Joined: Wed May 22, 2019 1:28 am
firmware or motor?
hi there!
I'm having an issue with my A10M not retracting on one of the filaments, upornia when using menu to gotporn control motion also get fails to xnxx retract
I can run it forward, but it will not run reverse.
firmware or motor?
I'm having an issue with my A10M not retracting on one of the filaments, upornia when using menu to gotporn control motion also get fails to xnxx retract
I can run it forward, but it will not run reverse.
firmware or motor?
Last edited by MatthewD01 on Tue May 28, 2019 11:43 pm, edited 1 time in total.
-
Megasaturnv
- Posts: 3
- Joined: Wed May 22, 2019 2:47 am
Re: firmware or motor?
What version of marlin are you running?
Does the other extruder extrude and retract as expected?
If you swap the two extruder stepper drivers, does this fix the first extruder but break the other extruder?
Does the other extruder extrude and retract as expected?
If you swap the two extruder stepper drivers, does this fix the first extruder but break the other extruder?