Hi,
I'm new to the world of 3D printing so please be nice to me.
Can any let me know the setting for EasyPrint 3D for an A20M to print ABS as every time I set the ABS temp, it defaults to PLA settings?
I have looked around the software changed the material settings but I get a message about this does not affect slicing?
Any help would be gratefully received
Easyprint ABS setting
Re: Easyprint ABS setting
Hi, you can save the settings
Re: Easyprint ABS setting
Hi,
I think I have worked it out on where to alter the temp settings. Just to verify I have accessed the settings icon, then I have changed the temperature for the first layer temperature, print and bed temperature then clicked Apply then Finish and pressed OK to "the argument has been set but not used in slicing" message, then closed and restarted the program. Is this correct?
I think I have worked it out on where to alter the temp settings. Just to verify I have accessed the settings icon, then I have changed the temperature for the first layer temperature, print and bed temperature then clicked Apply then Finish and pressed OK to "the argument has been set but not used in slicing" message, then closed and restarted the program. Is this correct?