Bad part or am I missing something??

TheFunkeyGibbon · Post by **TheFunkeyGibbon** » Fri May 10, 2019 7:53 am

I am part way through assembly when I need to install the two t-shaped linear bearings. One of the has the holes on the bottom correctly countersunk to allow an M3-6mm screw to fit flush when tightened. The other had the countersunk holes drilled next to the post rather than on the bottom.

: 20190510_004203.jpg (671.09 KiB) Viewed 5718 times

I have checked the instructions carefully but there doesn't appear to be a way to affix the latter and I am begining to think I have a incorrectly milled part. Has anybody else encountered this and am I misunderstanding something or do I have a part that needs replacing?

Post by **William** » Fri May 10, 2019 9:48 am

Hi, you can contact replacement.

TheFunkeyGibbon · Post by **TheFunkeyGibbon** » Fri May 10, 2019 3:05 pm

Thank you William, do I do that via the general contact page or is there a special email address?

Post by **William** » Fri May 10, 2019 4:23 pm

You can contract your Sales.

TheFunkeyGibbon · Post by **TheFunkeyGibbon** » Fri May 10, 2019 11:07 pm

I purchased from Amazon via GT-OFFICIAL UK. How do I contact GT-OFFICIAL UK?

TheFunkeyGibbon · Post by **TheFunkeyGibbon** » Sun May 12, 2019 8:25 pm

More bad parts.... I'm going for a refund. Terrible.

: 20190511150944__MG_9934.JPG (157.57 KiB) Viewed 5660 times

: 20190511160436__MG_9935.JPG (223.11 KiB) Viewed 5660 times

Geeetech

Bad part or am I missing something??

Bad part or am I missing something??

Re: Bad part or am I missing something??

Re: Bad part or am I missing something??

Re: Bad part or am I missing something??

Re: Bad part or am I missing something??

Re: Bad part or am I missing something??