3D Touch and Firmware

[SackofFluor]

Hey guys,

sorry to bother you, but i do have a problem to install the firmware for the 3d touch sensor.

I installed the sensor physically just to find out that i have to flash the firmware.
I downloaded the software here:

http://www.geeetech.com/forum/viewtopic ... 13&t=17181

then "open" marlin in arduino and uploaded that.

After that was done i restarted the machine and everything seemed fine. But i couldnt find the point in the menu to install the 3D touch sensor.
Then i realized that the printer is now not even recognized by my computer anymore...

Does anyone know what i can do now ?

Sincerely

Sack

[SackofFluor]

Thank you for the file. Do you know where i can get the 1.8.5. version? i only have the 1.8.9 version of arduino IDE

[William]

Refer to it:
https://www.arduino.cc/en/Main/OldSoftw ... ases#1.0.x

[SackofFluor]

Ok, so with the new files i was able to update the firmware again, it now has the menu buttons etc. and when i ask it to auto level it runs an auto level.

But if i now start it from cura with "print via usb" it does auto leveling and then at the end of it stops and doest start printing at all...

[William]

Hi,
Could you attach a video link?
I am a little confused.