SOLVED -A10M - Teflon tube goes out

[rodrigo.caravaca]

Hello all,
I have a new a10m and after 20 hours of printing i´m having this issue; The teflon tube goes out of the bowden mount. I tried to insert it again and press it hard but it goes out again.

I've seen some videos of people doing a quick fix with a clip... But i'm not sure that´s the right fix.
Any other options? anyone with the same trouble fixed it?

Thanks in advance.

[wotor]

Hi. I would replace connectors and maybe stock tube with Capricorn. If connection between tube and connector is weak you'll have retraction problem.

[rodrigo.caravaca]

Hi. I would replace connectors and maybe stock tube with Capricorn. If connection between tube and connector is weak you'll have retraction problem.

Hello and thanks bec your advise... Any suggestion about wich connector to use?. Ill have a look at capricorn tube too.

[wotor]

Unfortunately I have no recommendation for you. Read reviews on Amazon or eBay. maybe someone from this forum can recommend particular brand.
BTW I'm still using stock connectors, I replaced Bowden tube and I put some 3d printed clips.

[rodrigo.caravaca]

the small metal part inside the push fitting may have broken or come out and the fitting wont function anymore.

Thanks Vert,
I brought new PFTE tube and connectors, waiting to have them to change it. As soon as i dissasembly it, ill have a look to know whats the exact problem. The teflon tube has pressure marks where the connector press it, so im not so sure about if that´s broken or not... maybe it´s just the tube.

[William]

Hi,rodrigo
We will keep an eye on it.