A10M sudden layer shift ?

[SackofFluor]

Sudden frame shift.

Hey guys, i was printing some bigger piece with the "extra-fine" settings. After around 16h of print time the x-axis ( is that the one that moves "back and forth with the buildplate?), obviously had a problem, resulting in the layers from one leyer to the next be moved by 4-5mm, after that shift occured the printer continued printing without any hassle.

Any idea how to fix that ?

[William]

@SackofFluor
Hi!
How is it going on?Did vert's suggest work or not?

[SackofFluor]

Hey William,

Sorry i was busy printing. Actually i just decided that i will run with it until it shows up again... and so far it hasnt happend again.

Sincerely

Sack

[S.Bartfast]

the stock firmware uses 80.3 and 80.8 steps on xy any not whole number is subject to the rounding error where over time of the print you get +-1 step resulting in holes and bumps that could give a shift.

Could you explain this a little more?
I have a simular issue to the OP however I am getting constant shifts on both my X and Y axis and have tried everything else you mention above but don't understand what you are saying here.

Thanks.

Also, what should I do if I do have the a4988 (which I suspect I might):

M10A board.jpg (447.95 KiB) Viewed 6068 times

Here an photo of my latest print:

X_Y_shifts.jpg (491.44 KiB) Viewed 6068 times

[William]

Hi, regarding the adjustment of the belt,
You can refer to this:
How to adjust the x-axis belt: https://www.youtube.com/watch?v=QmrT1sPhvf8
How to adjust the y-axis belt: https://www.youtube.com/watch?v=ZoOaT5fkgfg

Regarding the speed of the print, you can refer to the range of 30-60mm/s;

If you need to adjust the driver board voltage, you can refer to this to make adjustments.

A4988 测量位置.jpg (192.77 KiB) Viewed 6064 times

Reference range 0.8-1.2V.

[S.Bartfast]

Hi, regarding the adjustment of the belt,
You can refer to this:
How to adjust the x-axis belt: https://www.youtube.com/watch?v=QmrT1sPhvf8
How to adjust the y-axis belt: https://www.youtube.com/watch?v=ZoOaT5fkgfg

Regarding the speed of the print, you can refer to the range of 30-60mm/s;

If you need to adjust the driver board voltage, you can refer to this to make adjustments.
A4988 测量位置.jpg
Reference range 0.8-1.2V.

Yes, I am aware of this. What I am wanting to know is what is meant by:

the stock firmware uses 80.3 and 80.8 steps on xy any not whole number is subject to the rounding error where over time of the print you get +-1 step resulting in holes and bumps that could give a shift.

And also how does one check if they have a "a4988" driver and what to do if I do have one.


Thanks.

[William]

Hi, Refers to the step value on each axis,
You can refer to this x/y algorithm.
http://www.geeetech.com/forum/viewtopic ... 66&t=68941