How to change the Dir/Step/Motion of the motor

[Admin]

The new version of the kit


Update:
You can use the V1.1 or V1.2 to change it:
https://github.com/Geeetech3D/Smartto-T ... plications


NOTE:
Added more options to further

smartto_motor_tool_1_0_forWin.zip

(7.32 MiB) Downloaded 1645 times

motor_tool_snapshot.png (75.85 KiB) Viewed 44567 times

-----------------------------------------------------------------------------------
-----------------------------------------------------------------------------------
Update:
Don't need click "factory default".You need to set correct vaule then restart your printer.
Here I will show you how to change the steps/mm.

MotorController.rar

(7.26 MiB) Downloaded 1584 times

1. First you need choose the right port
2. Click connect
3. Then get status.

TIM图片20180115181955.png (39.15 KiB) Viewed 45651 times

then you will get the parameter.

TIM图片20180115182014.png (42.71 KiB) Viewed 45651 times

Part 2
Change the direction of the motor
You should ensure X axis stop at here then change the value

A30-stop point.png (720.37 KiB) Viewed 45408 times

2.Refer to this pic and set the correct value

A30-Z反向.png (27.39 KiB) Viewed 45408 times

A30-z反向2.png (26.5 KiB) Viewed 45408 times

You can change the direction of all axis and extruder motor
As mentioned above, set it to "0" or "1"

[VooPoc]

Hi,

I have tried this on my E180 and I get the following error:

Start to initial configuration...
Error, Connecting failed! Details: There were serveral wrong data in profile!

Thanks,

[VooPoc]

Thanks, the new version fixed this, however it isn't committing the changes when I click "set".

[fr0gman]

Where is this data for the D200?

[William]

Where is this data for the D200?

Thanks for your feedback.
Could you give us more details of it?