Irregular Extrusion

apastor · Post by **apastor** » Thu Apr 04, 2019 12:03 am

Hello I have a Geeetech I3 Pro B a year ago.

I have been printing for months with PLA 1.75 with no problem. But 2 days ago suddenly began to print as shown the attached photo.

: IMG_20190403_135543.jpg (432.88 KiB) Viewed 4870 times

I have cleaned the extruder with the rod several times without success.

What I can do?

Post by **_kaktus_** » Thu Apr 04, 2019 1:30 pm

Hello.

Have you tried to print the same but with a different filament?

apastor · Post by **apastor** » Thu Apr 04, 2019 2:46 pm

I do not have another filament, I will buy another coil of different brand.
It is strange, because with this coil I have printed about 100gr without problem.

Thanks.

apastor · Post by **apastor** » Mon Apr 08, 2019 5:35 pm

After trying another new filament I still have the same problem.
I think the extruder is not pushing the filament hard enough.
What things can I check to verify the correct operation of the extruder?

Greetings.

Post by **William** » Thu Apr 11, 2019 5:28 pm

I think you need to refer to this post at first:
http://www.geeetech.com/forum/viewtopic ... 19&t=17097

Geeetech

Irregular Extrusion

Irregular Extrusion

Re: Irregular Extrusion

Re: Irregular Extrusion

Re: Irregular Extrusion

Re: Irregular Extrusion