On the a10m WHEN do you select the gradient. Its new to me and I have tried it a few times with no success.
I've switched the printer on, set up a gradient of 0 to 100 and gone back to the main menu. I then go and print form sd but it doesn't seem to work and I have a one colour print. I saw a youtube video where he said he had to wait till the print was going and then go into the mixer option and that how he does it.
What's the official way to do this. Manual is vague at best and I can't seem to find any help anywhere. I see people show prints but not show the process up to that in its entirety.
Getting gradient fill to work on printer.
Re: Getting gradient fill to work on printer.
Hello.
The handbook was released in the next version 2. Do you know it
The handbook was released in the next version 2. Do you know it
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.