Extruder going in the wrong direction

[awestom]

Hi guys,

​

At a loss on why my extruder is pushing the filament out instead of 'sucking' it in.

Code: Select all

 - Flashed the firmware and set
 - - #DEFINE INVERT_E0_DIR true
 - - #DEFINE INVERT_E0_DIR false
 - - - I also set all extruders to true/false
 - Swapped the plug around
 - Tried different printing software

​

Does anyone else have any other ideas?

All of those methods above result in my extruder pushing the filament out.

[William]

You need to refer to the FAQ for the I3 type printer.
It will show you how to change the dir of the motor.