Marlin 1.1.9 firmware for A10M (pre-built, fine-tuned, both with & without 3d touch) by aarli

heliport23 · Post by **heliport23** » Fri Mar 08, 2019 7:39 pm

Hi vert,

thank you for the information.

BR

Chingly · Post by **Chingly** » Sun Mar 10, 2019 12:33 pm

Where is the config_adv.h file in your build? cant find it anywhere on your github. Also, can you add filament runout?

bernte_one · Post by **bernte_one** » Wed Mar 13, 2019 10:46 pm

just take modified firmware by vert

put the right config... h file for your printer into the marlin directory before flashing

and enjoy

good work vert

Post by **William** » Thu Mar 14, 2019 10:25 am

This post has been locked.Try to use the default fw or the fw from vert.
viewtopic.php?f=92&t=68228

Geeetech

Marlin 1.1.9 firmware for A10M (pre-built, fine-tuned, both with & without 3d touch) by aarli

Re: Marlin 1.1.9 firmware for A10M (pre-built, fine-tuned, both with & without 3d touch) by aarli

Re: Marlin 1.1.9 firmware for A10M (pre-built, fine-tuned, both with & without 3d touch) by aarli

Re: Marlin 1.1.9 firmware for A10M (pre-built, fine-tuned, both with & without 3d touch) by aarli

Re: Marlin 1.1.9 firmware for A10M (pre-built, fine-tuned, both with & without 3d touch) by aarli