I have just assembled an A10M. When I went to connect it to the pc to update the firmware for 3D Touch. I get a problem where the pc recognises the printer on the port, but all the programs say "The connection failed with the following error a device connected to the system is not functioning" and will not connect.
I have checked the Sysytem paramaters e.g. Baud Rate is 250000 etc.
It is showing RAMPS (COM4) in Device Manager. I have run trobleshooting on the device but Windows can't find any errors.
Can anybody help me to resolve this.
I have shown the error message and the conection in Device manager in the attach files.
A10M Not connecting to pc via usb cable
A10M Not connecting to pc via usb cable
- Attachments
-
- Error1.PNG (3.5 KiB) Viewed 5522 times
-
- Error.PNG (7.08 KiB) Viewed 5522 times
Re: A10M Not connecting to pc via usb cable
Hello.
I have doubts whether you have installed the correct driver.
I have doubts whether you have installed the correct driver.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Re: A10M Not connecting to pc via usb cable
You can Click"Ramps"then try to install the drivers auto.Dragon161 wrote: ↑Sun Feb 17, 2019 12:03 amI have just assembled an A10M. When I went to connect it to the pc to update the firmware for 3D Touch. I get a problem where the pc recognises the printer on the port, but all the programs say "The connection failed with the following error a device connected to the system is not functioning" and will not connect.
I have checked the Sysytem paramaters e.g. Baud Rate is 250000 etc.
It is showing RAMPS (COM4) in Device Manager. I have run trobleshooting on the device but Windows can't find any errors.
Can anybody help me to resolve this.
I have shown the error message and the conection in Device manager in the attach files.
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: A10M Not connecting to pc via usb cable
Thank you for the reply's to my post. I have download the correct drivers and the printer is now communicating with the PC. 