print quality

Murphyprecht · Post by **Murphyprecht** » Sun Jan 20, 2019 8:20 pm

Hi folks, I built my I3 last week and made some prints with dubious quality. I'm happy to do some tinkering but as this is my first printer, I'm unsure where to begin. Any advice would be welcome. I think the box at the back of the cabin shows signs of z wobble, what do you guys think?

: 20190120_113657-2268x3024.jpg (312.54 KiB) Viewed 5579 times

: 20190120_113643-2268x3024.jpg (232.65 KiB) Viewed 5579 times

Murphyprecht · Post by **Murphyprecht** » Mon Jan 21, 2019 1:24 am

Ok, I changed my slicer to Cura and slowed the print to 40mm. Absolutely delighted.

: 20190120_171846-2268x3024.jpg (261.72 KiB) Viewed 5570 times

: 20190120_171831-2268x3024.jpg (303.44 KiB) Viewed 5570 times

jzero42 · Post by **jzero42** » Fri Jan 25, 2019 6:36 am

I think you should add a parts cooler fan and you can print the z-wobble fix (search on thingiverse), though I don't think that helped me that largely.
My benchy, same printer:

: bench2.jpg (106.56 KiB) Viewed 5540 times

: benc.jpg (138.54 KiB) Viewed 5540 times

Murphyprecht · Post by **Murphyprecht** » Fri Feb 01, 2019 6:32 pm

Yeah I've got the toroidal cooler on now but need to find the correct plug for the board lol

Geeetech

print quality

print quality

Re: print quality

Re: print quality

Re: print quality