Layershiftig on y axis

Post Reply
buttervonwaffle
Posts: 40
Joined: Sat Jan 05, 2019 6:12 pm

Re: Layershiftig on y axis

Post by buttervonwaffle » Sun Jan 06, 2019 1:18 pm

Yeah I know I didn't know that when I Initially Installed it. Needless to say I was ecstatic to find that out. Jerk was way to picky it really lightens the load when it comes to tuning it in. Thanks for bringing that to the threads and putting that work in, it is greatly appreciated!
If something I said just helped you out tremendously you can drop a little ramen money, the coding monkeys in my basement will appreciate it - Feed them here

You can private message me if you have any questions I might be able to help.
Top
hofschalk
Posts: 3
Joined: Wed Dec 19, 2018 6:43 pm

Re: Layershiftig on y axis

Post by hofschalk » Tue Jan 08, 2019 9:34 am

Stupid question: how do I install 2.0. I updated to 1.9 with a hex file via octoprint.
Top
Gandire48
Posts: 7
Joined: Thu Nov 22, 2018 2:19 am

Re: Layershiftig on y axis

Post by Gandire48 » Thu Jan 10, 2019 1:45 pm

I asked about layer shifting on the Facebook page . Repy was to lower the ACCel speed to 1000. I also lowered the Amax X to 2000, and the Amax Y 200 and lowered JERK to 10. Seems to help some parts I still run at 70-80 % speed
Top
bernte_one
Posts: 25
Joined: Fri Aug 24, 2018 4:39 pm

Re: Layershiftig on y axis

Post by bernte_one » Wed Jan 30, 2019 12:17 am

Hello Vert,

thanks for your work.

Will try your new Firmware too.
Last FW was from user rundundfun 1.9.1...?

it has 9 point levelling, has your firmware similar function included, i found this very usefull
Top
Post Reply

Return to “Geeetech A10 Series”