Geeetech A10 cannot get a firmware in!!!

[valentinguz]

Trying to upgrade the firmware it stopped and failed half way in. Now the screen doesn't show anything furthermore EasyPrint does not detect the printer so I cannot use the firmware Upgrador to fix it. Trying to use Arduino Ide to upload a firmware gives me this error:

Code: Select all

Arduino: 1.8.8 (Windows 10), Board: "Arduino/Genuino Mega or Mega 2560, ATmega2560 (Mega 2560)"

Sketch uses 151620 bytes (59%) of program storage space. Maximum is 253952 bytes.
Global variables use 5402 bytes (65%) of dynamic memory, leaving 2790 bytes for local variables. Maximum is 8192 bytes.
avrdude: stk500v2_ReceiveMessage(): timeout
avrdude: stk500v2_ReceiveMessage(): timeout
avrdude: stk500v2_ReceiveMessage(): timeout
avrdude: stk500v2_ReceiveMessage(): timeout
avrdude: stk500v2_ReceiveMessage(): timeout
avrdude: stk500v2_ReceiveMessage(): timeout
avrdude: stk500v2_getsync(): timeout communicating with programmer
An error occurred while uploading the sketch

This report would have more information with
"Show verbose output during compilation"
option enabled in File -> Preferences.

How can I fix it and get my printer back to factory settings?

[buttervonwaffle]

Did you happen to remove the sd card by chance? If not remove the sd card and then boot it up.