Replacement of the printhead. (Solved)

[WhippingBoy]

I have ordered the print head from the geeetech spare part site.
Did you guys manage to replace it without removing the wheels?

IMG_20181227_230901.jpg (302.19 KiB) Viewed 6985 times

IMG_20181227_221839.jpg (187.92 KiB) Viewed 6970 times

I'm still waiting for my part though...

[millenium7]

Yes, I did this today

The heater cartridge is easy. Unplug the green connector (it just pulls out) then loosen the 2 flathead screws and the wires come out, easy peasy
The thermister is a lot more tricky. I did manage to get the connector out in 1 piece, I got it down next to the wheel, then carefully rotated it sideways and managed it to get it out between the wheel and the plate. This was tricky and took a few minutes. Reinstallation was just as tricky

It would have been way faster to just remove that 1 wheel

[WhippingBoy]

Yes, I did this today

The heater cartridge is easy. Unplug the green connector (it just pulls out) then loosen the 2 flathead screws and the wires come out, easy peasy
The thermister is a lot more tricky. I did manage to get the connector out in 1 piece, I got it down next to the wheel, then carefully rotated it sideways and managed it to get it out between the wheel and the plate. This was tricky and took a few minutes. Reinstallation was just as tricky

It would have been way faster to just remove that 1 wheel

Thanks for your anwser, I will remove the bottom wheel and the strip. Hopefully my new part will arrive in the first week in the new year.

[WhippingBoy]

The new printer head is replaced after some help from vert.. regarding the eccentric nut...