hello my buzzard gets blocked and makes me a big dough.
Can you help me?
kind regards
nozzle that clogs at 10m
nozzle that clogs at 10m
- Attachments
-
- 20181219_163005.jpg (424.72 KiB) Viewed 5258 times
-
- 20181219_133418.jpg (550.2 KiB) Viewed 5258 times
Re: nozzle that clogs at 10m
Hello.
This can happen when the PTFE tube is not pushed deep enough.
It must be cut off evenly, it cannot be cut off at a slant
This can happen when the PTFE tube is not pushed deep enough.
It must be cut off evenly, it cannot be cut off at a slant
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Re: nozzle that clogs at 10m
Thank you very much it works again
good evening
and hello from France.
good evening
and hello from France.
Re: nozzle that clogs at 10m
Totally correct!
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!