Extruder leaking?

WhippingBoy · Post by **WhippingBoy** » Wed Dec 12, 2018 4:51 am

I unmounted the nozzle, to clean it.

Now it seems like it's leaking?

Any idea how to fix this?

Rainerw · Post by **Rainerw** » Wed Dec 12, 2018 6:03 am

Hi,
you heat up before mount the nozzle ?

WhippingBoy · Post by **WhippingBoy** » Wed Dec 12, 2018 6:08 am

Not sure.

Can I fix this?

Rainerw · Post by **Rainerw** » Wed Dec 12, 2018 6:16 am

unscrew the nozzle in hot state, clean it and screw it back in hot extruder

WhippingBoy · Post by **WhippingBoy** » Wed Dec 12, 2018 3:45 pm

Thanks.

How hot should it be?

Post by **_kaktus_** » Wed Dec 12, 2018 5:11 pm

Hello.

Heat it to the temperature you have set for printing.

Post by **William** » Thu Dec 13, 2018 2:53 pm

1.Heating the nozzle to 220C
2.Clean the hotend
3.Re-tightness the nozzle and the throat

WhippingBoy · Post by **WhippingBoy** » Sun Dec 16, 2018 7:02 am

William wrote: ↑
Thu Dec 13, 2018 2:53 pm
1.Heating the nozzle to 220C
2.Clean the hotend
3.Re-tightness the nozzle and the throat

Leaving the heat at 220 all the time even when mounting again?

Post by **_kaktus_** » Sun Dec 16, 2018 3:09 pm

Hi.

This is what it is all about to perform the assembly with hot components.

Post by **William** » Mon Dec 17, 2018 10:11 am

If you want to remove the nozzle off,you need to heating it to 220C at first.

Geeetech