Marlin 1.1.9 with & without bltouch + TMC2208

[Matboy]

I need help to make work my printer with the news drives TMC2208 for X,Y,Z,E0

[Matboy]

Yes, I have all mounted, but I wish optimizes the firmware of somebody need I can send it

[William]

I need help to make work my printer with the news drives TMC2208 for X,Y,Z,E0

How is it going on?
Dose it work with your printer?

[Matboy]

the printer goes well and very quiet even, I had to adjust the Vref of the drivers and the steps of Extruder, now I think I lost some step on the Y axis.

[Matboy]

But think that maybe the problem is cura because I print the same piece two time and all time I get the same defect

[Matboy]

I didn’t try

[Tomyuan]

You can try to use the slic3r then you can compare them :d