A10 - Simple E3D v6 hotend mount

[Wolle82]

Hi there,

is there someone out there who would share her/his E3D v6 hotend mount?
I did search on thingiverse... but I cant find one.

Need it for the classic A10 (Not A10M etc...)

[Wolle82]

Right... this could fit. Simple to mod.

Thx

[hatstand]

If your head cage as the fans on each side and five bolts on top you can fit it in place of the geeetech one, the five bolts clamp the heatsink.
I have just fitted one, used the original heat block with a new heatbreak ( thread size is different on the geeetech one larger). In the kit it came with five heatbreak's one all metal others ptfe tube, I am using a ptfe one at the moment and get very good prints.

Hope this helps.

[William]

Maybe you can refer to it:
https://www.thingiverse.com/thing:2993902
FIT:E3DV6
---------by Petsfang

[wrtony]

help i was just wondering after you installed your e3d v6 how did you get to tune the pid, for some reason mine wont tune

[William]

help i was just wondering after you installed your e3d v6 how did you get to tune the pid, for some reason mine wont tune

You refer to the reprap.com tuning it

[wrtony]

open your firmware and change pid max to 128 then auto tune