A10M How to calibrate both extruders?

[Landy]

Dear sir,
Hope that you are well,

I just tried to calibrate my extruders , on my geeetech A10M printer using S3D, and found out that both are slightly not calibrated.

Unfortunately, it seems that i was able to configure the W92=E only once, and not to have adedicated figure for each extruder.

Are you able to send detail information on how to calibrate both extruders? Which each one might have different W92 values.

Appreciate any help.

[Gingko]

In firmware, the E step has only one value, and you can check the description:
With this option each E stepper can have its own factors for the following movement settings. If fewer factors are given than the total number of extruders, the last value applies to the rest.