I purchased my first 3d printer and went with the geeetech a10. This thing was fun to assemble but I found a lack of cura resources/ or everyone else settings seemed different. So after a few weeks of trial and error I am going to post my researched settings so maybe it will help others find their best settings.
I did install the bl-touch auto level sensor and that did seem to help. But not entirely sure. I also don't need glue to keep the prints down for the most part anymore .
I am using pla plus /pro
My cura settings.
-
Cinderblockx7
- Posts: 2
- Joined: Thu Nov 15, 2018 10:42 pm
My cura settings.
- Attachments
-
- IMG_20181114_174024.jpg (383.94 KiB) Viewed 32526 times
-
- IMG_20181114_174032.jpg (408.13 KiB) Viewed 32526 times
-
- IMG_20181114_174039.jpg (263.21 KiB) Viewed 32526 times
-
- IMG_20181114_174047.jpg (310.48 KiB) Viewed 32526 times
-
- IMG_20181114_174050.jpg (346.27 KiB) Viewed 32526 times