Nozzle goes up few milimeters when the print starts

Jesus · Post by **Jesus** » Tue Sep 18, 2018 2:46 pm

Hi,

I've recently purchased a Geeetech I3 pro w. The bed has been leveled correctly but when the print starts the nozzle gets up a few mm and it makes that the filament doesn't adhere to the bed.

Regards,

Jesus · Post by **Jesus** » Fri Sep 21, 2018 2:05 pm

Hi,

Fixed, I've just realized that with the T8 threaded rod I needed to send the Gcode "M92 Z400" and "M500".

Regards.

wotroc · Post by **wotroc** » Fri Oct 12, 2018 1:35 pm

Hi I have this same problem how do you enter the codes thanks

Post by **_kaktus_** » Fri Oct 12, 2018 11:17 pm

Hello.

The slicer program you use has a command line.
You can also send commands after connection to a standard console, any program supporting serial communication.

wotroc · Post by **wotroc** » Sun Oct 14, 2018 9:37 am

OK I tried entering i think m400 but the z axis went all the way up and it crashed to the top, any chance you could show me how you entered your gcode details I don't really understand how this works thankyou so much for the reply Pete

Post by **_kaktus_** » Sun Oct 14, 2018 3:03 pm

Hello

Each slicer program in the manual control section has an edit box to send Gcode commands.

Geeetech

Nozzle goes up few milimeters when the print starts

Nozzle goes up few milimeters when the print starts

Re: Nozzle goes up few milimeters when the print starts

Re: Nozzle goes up few milimeters when the print starts

Re: Nozzle goes up few milimeters when the print starts

Re: Nozzle goes up few milimeters when the print starts

Re: Nozzle goes up few milimeters when the print starts