Hi
I have upgraded my firmware to the latest from your site GT2560 A+ BLtouch.
But i can't confirm the firmware on the printer. The About page has gone?
How do i confirm the Firmware?
Thanks for your help
Andy
identification Firmware
Re: identification Firmware
Hello
You can try to run the console on your computer, and then turn on the printer power. The printer sends an identification string each time it is started.
You will read it from the console.
In my case it looks like this:
You can try to run the console on your computer, and then turn on the printer power. The printer sends an identification string each time it is started.
You will read it from the console.
In my case it looks like this:
- konsola.png (37.69 KiB) Viewed 3789 times
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Re: identification Firmware
thanks for that i will give it a try.i was on 1.0.04 upgraded to latest for Bltouch A+. Just want to confirm the version.
Cheers
Andy