Problem with Geeetech i3 proB

[marco.marangia@libero.it]

Hi, i'm Marco, and i come from italy (My english is very bad and i'm sorry for this)!
Well, i have some problem with the firmware of my GEETECH i3 ProB, no one go on!
I saw somethings in this forum but i can't find a solution.
All the firmware don't run.
I have the screen with two long raw block, the sistem tell me that it can't find the sd module.
I can print with easy print 3d.
But with the last upgrade it don't go!

Where i can find a correct firmware. Or what i must to do to correct this problem?
thank you!

p.s. connection are all right!

[_kaktus_]

Hello.


Your problem is not a big one.

Maybe it makes a lot of trouble for you, because you still have little knowledge about firmware updates in your printer.
I am convinced that once you have successfully uploaded the right firmware and you will be able to enjoy a working printer.

At this stage I suggest that you try to get as much news as possible.
When you are still in need of help, you will precisely ask and present your problem.

Now I'll give you a useful link.
https://github.com/Geeetech3D/Prusa_I3_3Dprinter

[marco.marangia@libero.it]

it don't change nothing!
It still have a block raw!

with arduino 1.0.6 i upload firmware that you send to me, but it don't work!

[_kaktus_]

And did you upload a part commonly called bootloader?

[marco.marangia@libero.it]

And did you upload a part commonly called bootloader?

ehmmmm.... where is it?

p.s. now when i try to print z axis don't move!
It print at the same level!