Motors arent moving and both bed and extractor doesnt heat
-
SamBlack249
- Posts: 1
- Joined: Sun Sep 09, 2018 5:59 am
Motors arent moving and both bed and extractor doesnt heat
I have just finished building, i followed the guide on the manual and i also have looked at many videos. However none of my motors will move and my bed and extracter won't heat either?? anyone got any ideas. please it would be very helpful.
Re: Motors arent moving and both bed and extractor doesnt heat
Hi
In some versions of the controller, the logical part of the circuit can be powered from a USB port. However, this is not enough for the printer to work.
That's why I have a question if you haven't forgotten to switch on the main power supply
If you turned on the power and the problem occurs, check if it works properly.
In some versions of the controller, the logical part of the circuit can be powered from a USB port. However, this is not enough for the printer to work.
That's why I have a question if you haven't forgotten to switch on the main power supply
If you turned on the power and the problem occurs, check if it works properly.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.