How to calibrate the Z axis.
-
Metushelah
- Posts: 3
- Joined: Fri Sep 07, 2018 4:13 am
How to calibrate the Z axis.
Guys how did you calibrate the Z axis? my Z doesnt know where his home at he is just going there but not stopping
-
Metushelah
- Posts: 3
- Joined: Fri Sep 07, 2018 4:13 am
Re: How to calibrate the Z axis.
Thank you so much for helping guys!
anyway I found out that in thier manual they show the wrong place to connect the Z endstop, and I just changed in the Arduino, the Configuration.h tab the const bool Z_MIN_ENDSTOP_INVERTING to false and const bool Z_MAX_ENDSTOP_INVERTING to false
This is the right connections to the board GT2560 unlike thier manual which is wrong.
http://www.geeetech.com/wiki/index.php/ ... wiring.jpg
anyway I found out that in thier manual they show the wrong place to connect the Z endstop, and I just changed in the Arduino, the Configuration.h tab the const bool Z_MIN_ENDSTOP_INVERTING to false and const bool Z_MAX_ENDSTOP_INVERTING to false
This is the right connections to the board GT2560 unlike thier manual which is wrong.
http://www.geeetech.com/wiki/index.php/ ... wiring.jpg
