Printing problems

[Derzelas]

Hi guys,

I hope someone ran into this problem and knows how to fix:D
I've been trying to print the calibration cube but some inconsistencies in the print showed and i don't know how to fix.

Bellow are some images of the cube after printing. Any sort of help is greatly appreciated. Thank you

IMG_20180716_112522.jpg (188.34 KiB) Viewed 6791 times

IMG_20180716_112511.jpg (220.98 KiB) Viewed 6791 times

IMG_20180716_112504.jpg (212.2 KiB) Viewed 6791 times

IMG_20180716_112442.jpg (182.03 KiB) Viewed 6791 times

IMG_20180716_112437.jpg (187.65 KiB) Viewed 6791 times

[martinyazz]

My limited knowledge points to an overheating issue. Either the head is too hot 200 should be good or lack of cooling on hot end.
I don’t know if this is of any help or not

[Gingko]

Agree with @martinyazz

And for the first and second pictures, you can try to increase the overlap and first layer width.

[pastranario3]

Hi guys,

I hope someone ran into this problem and knows how to fix:D
I've been trying to print the calibration cube but some inconsistencies in the print showed and i don't know how to fix.

Bellow are some images of the cube after printing. Any sort of help is greatly appreciated. Thank you

IMG_20180716_112522.jpg
IMG_20180716_112511.jpg
IMG_20180716_112504.jpg
IMG_20180716_112442.jpg
IMG_20180716_112437.jpg

As you solved the problems of the first photos, the same thing happens to me ...