Hi to all,
I try to start my first print with I3B but I got some trouble. I tried to load my sample to the printer but set temperature are not loaded and printer doesn't start.
Any help?
Thanks in advanced.
First print problem
First print problem
- Attachments
-
- IMG_20180715_122338.jpg (211.33 KiB) Viewed 4799 times
Re: First print problem
Hi
Which software do you use?
Have you tried to make a head movement from the slicer panel?
Which software do you use?
Have you tried to make a head movement from the slicer panel?
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.
Re: First print problem
Did you print through SD card or USB?
Can you directly set temperature through LCD or slicer software?
Can you directly set temperature through LCD or slicer software?
Re: First print problem
Hi
I use the one installed, no software upgrade is done.
I connect the printer via USB.
No I'm not able to move the extruder by slicer
What can I do?
I use the one installed, no software upgrade is done.
I connect the printer via USB.
No I'm not able to move the extruder by slicer
What can I do?