cant seem to calibrate my axis on my geeetech pro w

[hi-jam]

Just finished the build of my geeetech I3 pro W and z axis wont calibrate, plus i was checking the wiring on the board and all looks good but i did hit the reset on the board and now my desplay wont work unless it is plugged into my laptop. Any idea or help would be great.

[Gingko]

Reburn the firmware to have a try.

[Gingko]

For Z-axis issue, you can check this post first:
http://geeetech.com/forum/viewtopic.php?f=82&t=60931

[donny]

calibrate it like its binding on you or the two motors are not level? use bearing grease on all the rods