Hi All can someone explain what needs to be done know I have built the Delta printer when I home it just hits the end stops and keeps clickingboth with repetier host or from the LCD but I don't know what the next stage is to get the printer working any help would be appreciated.
Thanks
Steve
Delta G2s
Re: Delta G2s
Hi,
I had experienced the same issue. After checking the endstops and wirings that were ok, I changed the stepper driver (polulu) of the axis and it solved the issue. I think the driver was dead.
Anyway, and it's not very well explained in the instructions, you must set the voltage of each stepper driver. They are not setup in the factory !
À Google search will give you a lot of help for a right setup.
I had experienced the same issue. After checking the endstops and wirings that were ok, I changed the stepper driver (polulu) of the axis and it solved the issue. I think the driver was dead.
Anyway, and it's not very well explained in the instructions, you must set the voltage of each stepper driver. They are not setup in the factory !
À Google search will give you a lot of help for a right setup.