Hello,
I put n print a piece of sd and after 1 and 50 the printer stopped. I stayed on the light at 210 degrees and the bed at 45 degrees. I had to reset to turn off the print (the printer is not connected to the PC)
How come from this problem?
Solutions.
Thank you
block printing after a 1 and 50 minutes
Re: block printing after a 1 and 50 minutes
I think you should check the motor temp
If it were too hot,you need to adjust the voltage of the A4988
You can decrease the A4988 to 0.7V then have a try
If it were too hot,you need to adjust the voltage of the A4988
You can decrease the A4988 to 0.7V then have a try
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: block printing after a 1 and 50 minutes
if I'm not mistaken I think they are at 0.82