Two-color printing configuration

gpau · Post by **gpau** » Thu Mar 22, 2018 4:31 am

How do I set up the printer for two-color printing at both the software and hardware level?
I currently use the new firmware for the Geeetech i3 Pro C.
I have not been able to print in two colors yet.

Thank you

Post by **William** » Thu Mar 22, 2018 6:45 pm

You need to select dual extruder at your printing setting

gpau · Post by **gpau** » Fri Mar 23, 2018 1:51 am

that ok, but what settings should I put

gpau · Post by **gpau** » Fri Mar 23, 2018 1:54 am

this fact, but what settings should I put in the program?

Post by **William** » Fri Mar 23, 2018 2:17 pm

You need to refer to this user manual at first

: ProC-1.png (243.92 KiB) Viewed 14497 times

: PROC-2.png (101.24 KiB) Viewed 14497 times

: PROC-3.png (195.53 KiB) Viewed 14497 times

gpau · Post by **gpau** » Wed Apr 04, 2018 12:59 am

Do you have a repetier-host configuration for the i3 Pro C?

Thank you

Post by **William** » Wed Apr 04, 2018 8:35 pm

You can refer it

BR365 · Post by **BR365** » Thu Apr 19, 2018 3:33 am

I didn't understand, how to configure and calibrate the dual extruder on our I3 C Pro printer, nor how to select, which extruder should be used for which part.

Furthermore, I can't find a possibility, to move the extruder to a specific x-y-coordinate. E.g. I would like to set for Extruder 1, go to x:100, y:100
Then, I do the same for extruder 2 and I would be able to calculate the offset.

Is there a manual or manpage available, to follow step by step?

Thanks,
Moritz

Geeetech

Two-color printing configuration

Two-color printing configuration

Re: Two-color printing configuration

Re: Two-color printing configuration

Re: Two-color printing configuration

Re: Two-color printing configuration

Re: Two-color printing configuration

Re: Two-color printing configuration

Re: Two-color printing configuration