Hello,
I don't understand how to change the nozzle (to use the replacement part) on the E180. Is there a special trick to do this? I'm not seeing anything that I can pull/push to release the nozzle.
Pictures would be appreciated :)
Changing the nozzle
Re: Changing the nozzle
Hi,
I had an answer from Jocelin from Geeetech, so I'm sharing the pictures with you.
The bit to pull didn't move when using my fingers, so I thought it couldn't move. Using a tool did the trick, I could pull it without problem and remove the nozzle. I didn't need to change the nozzle after all (wasn't cloged or anything) but I wanted to know how to do it...
I had an answer from Jocelin from Geeetech, so I'm sharing the pictures with you.
The bit to pull didn't move when using my fingers, so I thought it couldn't move. Using a tool did the trick, I could pull it without problem and remove the nozzle. I didn't need to change the nozzle after all (wasn't cloged or anything) but I wanted to know how to do it...
- Attachments
-
- Geeetech-E180-Nozzle-Change2.jpg (54.85 KiB) Viewed 12440 times
-
- Geeetech-E180-Nozzle-Change1.jpg (56.92 KiB) Viewed 12440 times
Re: Changing the nozzle
A more detail:
You should heating the nozzle up to 200C and then remove the filament off
Then you can try it and remove it off
You should heating the nozzle up to 200C and then remove the filament off
Then you can try it and remove it off
-Keep your mind and try to test it. 
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun！-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: Changing the nozzle
Hello. I cannot pull up the lever. What tool did you use. In case the lever is stuck may I use a bit of W40?