Firmware for Pro W

[Wideoman]

good day

I have a Pro W with the current firmware 1.03 and would like to equip it with a capacitive sensor. Unfortunately, I need a firmware> 1.04, I would have to modify this myself, because unfortunately I find no newer firmware with Googel. Therefore, the question of whether someone has already done this and if so, could this person provide it?

[William]

You can download the Marlin1.1.8 for prob firmware at forum

[Wideoman]

This would I have to adjust for the Pro W yet? Am a complete newcomer and therefore I know myself in the config files not good.

[Wideoman]

Have adapted the software for the Pro W and would like to share it for others in the forum.

Marlin 1.1.7
Printer Pro W with capacitive sensor
[url=https://www.joehl.org/share/Marlin-1.1.8_2.zip]Download ProW Firmware[/url]

The Sensorkit have i from:
[url=http://3d-proto.de/index.php?p=tips_autobed#Autobed]Distributor for Sensor in Germany[/url]

Mounting for sensor:
[url=https://www.thingiverse.com/thing:1760712]Mounting to print out[/url]

[William]

Thanks!That is great info！

[JustinSB]

I have a Pro W with the Geeetech 3D-Touch installed, as opposed to a capacitive sensor. What changes would I need to make to this firmware please.

[William]

You should refer to 3dtouch user manual at first
Then you should change the configuration.h and pins.h file
(Don't forget to change the pin value of Servo0 to 11)

[1138]

[quote=JustinSB post_id=82564 time=1518454915 user_id=62140]
I have a Pro W with the Geeetech 3D-Touch installed, as opposed to a capacitive sensor. What changes would I need to make to this firmware please.
[/quote]

If the board is GT2560A+, an example configuration is provided in the official Marlin repo, branch 'bugfix-1.1.x'. Yo do not need to modify pins.h anymore, just set the board to 'BOARD_GT2560_REV_A_PLUS'. See viewtopic.php?p=82486#p82439

Note that those configurations expect the sensor to be connected to Z_MAX, as opposed to the recommended setup by Geeetech. Please, read both the readme and viewtopic.php?f=27&t=18263&start=280#p82546.

[sonesh]

How can I amend this for having no Capacitive or 3dTouch sensor?

[William]

How can I amend this for having no Capacitive or 3dTouch sensor?

You can download the Marlin firmware 1.1.8 and change some value then upload it to your printer