Latest Marlin bugfix-1.1.x branch for PI3 Pro B

[NiklasO]

So, first post updated with the bugfix-1.1.x-branch, fresh clone. Try it out and tell me if it works.

Don't forget M502 followed by M500. Some stuff have changed.

[Artsi]

My only problem is that when i'm homing my extruder it's going to center of bed and i don't want that. I think that when homing extruder it should go in down left corner? My print starts from middle of bed and that's okay, but i want to change my extruder place when homing it. I have tried to change it with M206 command and saved it with M500 but it's still going to center of bed when homing?

I'm using Repetier Host and i can't change that homing place from it's setting either...

[NiklasO]

Turn off safe homing.

[Artsi]

Thanks works perfectly. Just having problems with extruding, but let's see can i get it work.

[schlaubi666]

i have an i3 Pro X, what to change to use this firmware ?

[William]

i have an i3 Pro X, what to change to use this firmware ?

Hi,you can refer to this post:http://www.geeetech.com/forum/viewtopic ... 20&t=17046.

[NiklasO2]

Sorry folks. I can't answer PMs or edit this thread. I changed the e-mail address for my NiklasO account and because of that the account got deactivated (administrator has to activate again). I have e-mailed Geeetech and spoke to them using Whatsapp but my NiklasO account is still deactivated since like 2 weeks now...

[William]

Sorry folks. I can't answer PMs or edit this thread. I changed the e-mail address for my NiklasO account and because of that the account got deactivated (administrator has to activate again). I have e-mailed Geeetech and spoke to them using Whatsapp but my NiklasO account is still deactivated since like 2 weeks now...

Hi,I have contacted the administrator about your case.They have activated your NiklasO account.Please try to log in again.

[NiklasO]

Sorry folks. I can't answer PMs or edit this thread. I changed the e-mail address for my NiklasO account and because of that the account got deactivated (administrator has to activate again). I have e-mailed Geeetech and spoke to them using Whatsapp but my NiklasO account is still deactivated since like 2 weeks now...

Hi,I have contacted the administrator about your case.They have activated your NiklasO account.Please try to log in again.

Thanks! I need to change the mail address again for this account. Please activate NiklasO and NiklasO2 again. Thanks!

[fraggle]

Anyone got a working config for the new marlin 1.1.3 stable version ?