3dTouch problem

mgros · Post by **mgros** » Sat May 13, 2017 4:15 am

It is normal, for the pin, to fall due to the vibrations during the infill process?
Any suggestion or help to avoid it?
Thanks in advance.

Mariano.

Post by **William** » Tue May 16, 2017 9:42 am

Hi,could you post some videos to show how do the pin fall due to the vibrations?

mgros · Post by **mgros** » Wed May 17, 2017 4:31 am

you can see the accidental deploy at second 9.
https://youtu.be/5Jmm46Bd0LM
The pin fall, touch the bet and not go up.

Thanks for your help.

Post by **William** » Mon May 22, 2017 5:27 pm

mgros wrote:you can see the accidental deploy at second 9.
https://youtu.be/5Jmm46Bd0LM
The pin fall, touch the bet and not go up.

Thanks for your help.

After watching this video,I think it's because the magnet at the top of the probe is short of magnetic force.So here are some tips for you.
1、Change a new probe，especially the magnet inside the sensor;
2、Adjust the screw on the top of the sensor a little higher,like the picture showing.

Geeetech

3dTouch problem

3dTouch problem

Re: 3dTouch problem

Re: 3dTouch problem

Re: 3dTouch problem