Luminated Print Head for Geeetech Latest Rostock Delta 301

[Armstrong]

There was no light designed in Rostock Delta 301, I had to use a small torch in order to observe my first few layer on the platform. I have now added 3 white LEDs surrounding the print extrude. The LED brackets are 3D printed. The LEDs are connected in serial and power supplied by 9V DC through a power regulator.

[bang]

Great

[Percy]

Hi I love the lights but that is not why I am contacting you or trying to contact you. I bought my 301 two or three months ago but I have not managed to set it up! Yes apart from the head scratching my bed! Were did you find the proper setup instructions? I have tried the forum and the internet but I cant get mine setup. Could you please tell me how you managed to do it?
Cheers for now Percy

[William]

Hi,here is instructional video:https://www.youtube.com/playlist?list=P ... TXEW2gDPrF;
And here is building Instruction:https://www.geeetech.com/Documents/Geee ... uction.pdf.

[RachelD]

Just loved this. Thanks for sharing it here. I am new to this forum community and I get know earn knowledge I can say. Keep up the good work.

[rohanjoshi]

Great Post! I have read it fully. This is a very inspiring article for me. Thank you so much.