Home problems with Pro C

[eviljeff]

After eliminating the inverted X-axis problem, now is the X axis Z, do not stop at the end positions.

The motors do not stop, continue to run and jump belts. I first tried to give the home position from the LCD, but nothing. Then from Repetier Host and still nothing. Then I decided to remove the X-axis motor, keep the truck resting on the switch and after a while it stopped. I reassembled and tried it and it worked.

But with the Z axis I'havvent the same luck and after the emergency STOP from Repetier, also the Y-axis does not work again.

But how much confusion you did with that mainboard!!!

[eviljeff]

Nobody?

[William]

maybe the endstop problem .

[eviljeff]

No...i've tested all endstops with M119, and all works.