Rostock 301 Intermittent Pausing

Post Reply
JohnQuix
Posts: 36
Joined: Mon Aug 01, 2016 8:20 pm

Rostock 301 Intermittent Pausing

Post by JohnQuix » Fri Feb 17, 2017 4:10 am

Hello,

My Rostock 301 pauses every layer leaving big blobs of filament wherever it stops. How do I fix this? Is it just a firmware issue?
Top
bang
Posts: 402
Joined: Wed Dec 28, 2016 2:12 pm

Re: Rostock 301 Intermittent Pausing

Post by bang » Tue Feb 21, 2017 11:45 am

I think it may be a slicer issue?Did you try different slicer tools and models?
And did this happen before?
Top
JohnQuix
Posts: 36
Joined: Mon Aug 01, 2016 8:20 pm

Re: Rostock 301 Intermittent Pausing

Post by JohnQuix » Tue Feb 21, 2017 11:54 am

It's not the slicer.

Happens on Slic3r and Simplify3D and it also happens printing from SD and through USB through Repetier.
Top
Vladimiir
Posts: 1
Joined: Wed Mar 01, 2017 7:56 pm

Re: Rostock 301 Intermittent Pausing

Post by Vladimiir » Thu Mar 02, 2017 1:18 am

I have the same Problem. I think the Problem in the firmware, in the calculation of acceleration. I installed the latest firmware Rostock301_V1.0.02.zip. Remained problem (((. I'll wait for a new firmware or replaced the board.
viewtopic.php?f=20&t=18167&hilit=Rostock+301#p32556
viewtopic.php?f=20&t=17046
Top
Post Reply

Return to “Others”