Heated Bed upgrade question

[malnical]

So I am looking to redo my geeetech prusa i3 dual head printed to a larger frame and was looking to put a 300 by 300 bed on it.
what I would like to do is use this one.
https://folgertech.com/collections/heat ... 0x300-ft-5

However I noticed that it is a 12v 19 amps. and my understanding is that the GT2560 only supports up to a 12 amp heated bed, is there anything I can do to make this work? (Short of using a different board).

[malnical]

I am guessing a larger power supply like this one https://www.amazon.com/eTopxizu-Univers ... supply+30a

and using either one of these

https://www.amazon.com/Printer-Heated-E ... 9MNKZ9D8A5

or

https://www.amazon.com/Baomain-SSR-100D ... 0797D0GNMV

any thoughts?